Fire Dragon Flam Thrower Up To A Meter Long Flam and Sound for Cars with Catalytic Converter

Installation

• Check the 12V/DC power cord positive electrode of the distribution board, and connect one of it's cut ends to white (close to coil), the other cut to yellow.

• The black is connected with the ground wire.

• Red is connected with red of the switch, another black of the switch is connected with power ON.

• Green connects with the positive electrode of the new coil, negative electrode with the ground, in the middle are high-voltage cord and spark plug.

• The spark plug connects to 10cm from the hole of tailpipe.

This product requires to replace exhaust pipe and catalyst.Operation

• First warm up the car.

• Pull the turning speed to more than 3500, keep the accelerator, push down the button for

• 1 to 2 seconds, and then let it go when the exhause pipe gives out flame.

• Keep the flame for less than 2 seconds.

To avoid damage on engine or flame extinguishing.Warning

• This product is for people with special skills or special professions.

• It must not be used on roads, public areas or among moving vehicles.

• Take care not to get close to gas station, electric appliances or liquid fuel material when the flame is one.

• This product has certain danger. The owner must take full responsibility if causing bad effecton the vehicle or engine.